Page 1
Fender Eliminator Kit This product is not DOT approved. Yoshimura R&D of America, Inc. is not liable or responsible for any resulting event caused by the installation of this product. Check with local laws and regulations for compliance prior to installation and use. This product is not intended for use on public highways.
Page 2
1. Install Yoshimura LED fender eliminator light onto license plate bracket. 2. Using the connectors provided in the kit, connect the Yoshimura Fender Eliminator wires to the stock license plate light connector as follows: Red wire goes to Red wire; Black wire goes to black w/ yellow stripe.
Page 3
5. For Ninja 1000, lift lower tail section back up to the subframe and secure using the provided hardware. 6. Secure assembled Yoshimura Fender eliminator to subframe using the stock bolts in conjunction with the washers and nuts provided in the kit.