Yoshimura 070BG123100 Manual

Fender eliminator kit honda cb300r

Download this manual

RESEARCH&DEVELOPMENT OF AMERICA, INC.

5420 DANIELS STREET STE A, CHINO CA., 91710 · (800) 634-9166 · (909) 628-4722 · FAX (909) 591-2198

www.yoshimura-rd.com

FENDER ELIMINATOR KIT

070BG123100

Honda CB300R

THIS PRODUCT IS NOT DOT APPROVED.

Yoshimura R&D of America, Inc. is not liable or responsible for any resulting event caused by the

installation of this product. Check with local laws and regulations for compliance prior to

installation and use. This product is not intended for use on public highways.

Page 1 Honda CB300R THIS PRODUCT IS NOT DOT APPROVED. Yoshimura R&D of America, Inc. is not liable or responsible for any resulting event caused by the installation of this product. Check with local laws and regulations for compliance prior to installation and use. This product is not intended for use on public highways.
Page 2 073BG-HON-1 Turn Signal Wire Adapters 072BGLTSR Yoshimura LED Turn Signal Kit w/ Relay 072BGLTSR-S Yoshimura Sequential LED Turn Signal Kit w/ Relay 070BGUNVTBKT Yoshimura Turn Signal Bracket Kit, Standard 070BG12121TSBKT Yoshimura Turn Signal Bracket Kit, Corner ** Not shown on diagram.
Page 3 6. Using the BN-SSS-22-18, solder shrink connectors provided in the kit, connect the Yoshimura license plate light wires to the stock license plate light wires as follows: Black Wire -to- Green (-) 2. Install (No. 4) 070BG-LH-K1, fender eliminator...
Page 4 c) Making sure that the stripped ends are centered, heat the center of the connector evenly until the solder begins to liquify. d) Allow to cool completely and tug both ends of the wires to verify that connection is secured. Scan for link to solder shrink connector instruction video.