Cut-Off Clutch; Operating Instructions; Initial Operation; Description Of The Keyboard - Gaspardo PRECIMAT Use And Assembly Instructions / Spare Parts

ENGLISH

3.3.6 CUT-OFF CLUTCH

The cable must be protected against squeezing and other dama-
ges.
The left aggreagate is occupied with the number 1 (in driving-
direction).
Colours of the wires:
br = brown .......... (+ 12 V)
bl = blue ............. (Ground)
18
USE AND MAINTENANCE

3.4 OPERATING INSTRUCTIONS

3.4.1 INITIAL OPERATION

When switched on, the computer runs through a self-test. After
completion the function, used before last switch-off, is automati-
cally selected.
In case of an electronic fault the display shows:
HALP 00 or HALP 88.
In this case return the device for repair.

3.4.2 DESCRIPTION OF THE KEYBOARD

The keyboard is devided into 4 parts:
- input-keys (input/change of data);
- machine-data keys (setting of the machine-specific parameters);
- control-keys (switch-on and off of the monitoring);
- function-keys (indication of the detected dates).

3.4.3 INPUT-KEYS

3.4.3.1 Device on/off
By pressing "on/off" key, the device is switched-on.
Another pressing of "on/off" and the device is switched-off.
If the supply voltage for example drops below 9 volts when the
tractor is started, the computer is switched-off automatically. In
this case it must be switched-on again with key.
3.4.3.2 Enter - key
The "ENTER" key serves for the confirmation of data-inputs. Each
value of the machine-data that has been changed with the keys
"+/-" has to be confirmed with the "ENTER" key. Otherwise the
change is not valid and the computer still works with the old values.
3.4.3.3 Start - function
By pressing the keys "C" and "ENTER" at simultaneously the
start-function is activated. That means that the counters for area,
time and distance are set to 0. The time counting is started again
automatically by pressing these keys. This function has to be ac-
tivated before start of working.
3.4.3.4 Adjustment keys +/-
With the first pressing of the "+" or "-". key the indication jumps one
position into the wanted direction.
If you press the key again the indication runs continously until the
key is no longer pressed.
3.4.3.5 Machine-data keys
The computer needs the following data: Impulses/100m, working-
width , number of aggregates and the application rate "seeds/ha".
3.4.3.6 "Working-width" key
This key is used to enter actual working width:
- Press "Working-width" key
- Select value with the keys "+" and "-"
- Press "ENTER" key
Afterwards the entered value should be checked again by pressing
"Working-width" key.

cod. G19503910