Table of Contents
Advertisement
Section 5
Mounting
5.3
22
Mounting the IED
The IED can be rack, wall or flush mounted with the use of different mounting kits, see
figure 2.
An additional box of type RHGS can be mounted to one side of a 1/2 or 3/4 IED.
The different mounting kits contain all parts needed including screws and assembly
instructions. The following mounting kits are available:
•
Flush mounting kit
•
19" Panel (rack) mounting kit
•
Wall mounting kit
•
Side-by-side mounting kit
The same mounting kit is used for side-by-side rack mounting and side-by-side flush
mounting.
The mounting kits must be ordered separately when ordering an IED.
They are available as options on the ordering sheet in the Accessories
guide, see section
Generally, all the screws included in delivered mounting kits are of Torx type and a
screwdriver of the same type is needed (Tx10, Tx15, Tx20 and Tx25).
IEC02000684
V1 EN
Use only the screws included in the mounting kit when mounting the
plates and the angles on the IED. Screws with wrong dimension may
damage the PCBs inside the IED.
"Related
documents".
1MRK514019-UEN A
670 series 2.0 IEC
Installation manual
Advertisement
Table of Contents
