Carrier AquaForce 30XV140-500 Installation Instructions Manual page 116

Table 14 — 30XV160-500 Electrical Data, Dual Point Power, Standard Tier, Variable Speed Fans
UNIT VOLTAGE
UNIT
30XV Supplied
V(3 Ph) Hz
Min Max
208/230 60 187 253
380 60 342 418
400 60 360 440
460 60 414 506
575 60 518 633
160
380 50 342 418
400 50 360 440
415 50 374 457
440 50 396 484
208/230 60 187 253
380 60 342 418
400 60 360 440
460 60 414 506
575 60 518 633
180
380 50 342 418
400 50 360 440
415 50 374 457
440 50 396 484
208/230 60 187 253
380 60 342 418
400 60 360 440
460 60 414 506
575 60 518 633
200
380 50 342 418
400 50 360 440
415 50 374 457
440 50 396 484
380 60 342 418
400 60 360 440
460 60 414 506
575 60 518 633
225
380 50 342 418
400 50 360 440
415 50 374 457
440 50 396 484
380 60 342 418
400 60 360 440
460 60 414 506
575 60 518 633
250
380 50 342 418
400 50 360 440
415 50 374 457
440 50 396 484
380 60 342 418
400 60 360 440
460 60 414 506
575 60 518 633
275
380 50 342 418
400 50 360 440
415 50 374 457
440 50 396 484
LEGEND
MCA — Minimum Circuit Amps
MOCP — Maximum Overcurrent Protection
VFD — Variable Frequency Drive
NOTES:
1. Units are suitable for use on electrical systems where voltage
supplied to the unit terminals is not below or above the listed
minimum and maximum limits. Maximum allowable phase imbal-
ance is: voltage, 2%; amps 10%.
2. Evaporator heater (where applicable) is wired into the control cir-
cuit so it is always operable as long as the control power supply
disconnect is on, even if any safety device is open.
3. For MCA that is less than or equal to 380 amps, 3 conductors are
required.
For MCA between 381-760 amps, 6 conductors are required.
For MCA between 761-1140 amps, 9 conductors are required.
For MCA between 1141-1520 amps, 12 conductors are required.
Calculation of conductors required is based on 75 C copper wire.
STANDARD CONDENSER FANS
NUMBER OF
COND FANS
MCA
CKT 1 CKT 2 CKT 1 CKT 2 CKT 1 CKT 2 CKT 1 CKT 2 CKT 1 CKT 2 CKT 1 CKT 2 CKT 1 CKT 2
4 4 379.6 366.8 600
4 4 207.9 200.8 350
4 4 198.1 191.0 300
4 4 171.5 165.7 250
4 4 138.4 133.8 225
4 4 212.0 205.0 350
4 4 202.2 195.2 300
4 4 195.2 188.2 300
4 4 184.1 177.1 300
4 4 435.9 423.0 700
4 4 239.1 232.1 400
4 4 226.8 219.8 350
4 4 196.9 191.1 300
4 4 158.4 153.8 250
4 4 244.5 237.5 400
4 4 233.5 226.4 350
4 4 225.2 218.2 350
4 4 212.9 205.8 350
5 5 451.7 438.8 700
5 5 248.1 241.0 400
5 5 235.5 228.5 350
5 5 204.1 198.3 300
5 5 164.4 159.7 250
5 5 253.6 246.5 400
5 5 242.3 235.2 400
5 5 233.8 226.8 350
5 5 220.0 212.9 350
6 4 338.0 212.1 500
6 4 321.4 202.3 500
6 4 278.9 174.8 450
6 4 223.4 140.0 350
6 4 344.9 217.5 500
6 4 328.3 207.7 500
6 4 317.2 199.4 500
6 4 299.3 188.3 500
6 6 326.7 320.0 500
6 6 310.1 303.4 500
6 6 269.0 263.4 450
6 6 216.3 211.9 350
6 6 333.6 326.9 500
6 6 318.2 311.5 500
6 6 307.1 300.4 500
6 6 289.2 282.5 450
6 6 337.9 331.2 500
6 6 321.4 314.7 500
6 6 278.7 273.2 450
6 6 223.8 219.4 350
6 6 344.8 338.1 500
6 6 328.2 321.5 500
6 6 317.1 310.4 500
6 6 299.2 292.5 500
HIGH STATIC CONDENSER FANS
REC FUSE
MOCP MCA
SIZE
600 450 450 384.8
300 250 250 213.0
300 250 250 203.1
250 225 200 175.9
225 175 175 141.9
350 250 250 217.3
300 250 250 207.2
300 250 225 200.1
300 225 225 188.7
700 600 600 441.1
400 300 300 244.3
350 300 300 231.8
300 250 250 201.3
250 200 200 161.9
400 300 300 249.8
350 300 300 238.5
350 300 300 230.1
350 300 250 217.4
700 600 600 458.1
400 300 300 254.5
350 300 300 241.8
300 250 250 209.6
250 200 200 168.7
400 300 300 260.2
400 300 300 248.5
350 300 300 239.9
350 300 300 225.7
350 400 300 345.8
300 400 250 329.0
300 350 225 285.5
225 300 175 228.6
350 450 300 352.8
350 400 250 335.8
300 400 250 324.4
300 400 225 306.1
500 400 400 334.5
500 400 400 317.7
450 350 350 275.6
350 300 300 221.5
500 400 400 341.5
500 400 400 325.7
500 400 400 314.4
450 350 350 296.1
500 400 400 345.7
500 400 400 328.9
450 350 350 285.3
350 300 300 229.0
500 450 400 352.7
500 400 400 335.7
500 400 400 324.4
500 400 350 306.1
4. Based on the operational characteristics of a VFD, the "inrush"
current normally associated with a chiller is limited and will be
lower than the MCA rating of the chiller.
5. Wiring for main field supply must be rated 75 C minimum. Use
copper for all units. Refer to Table 8 for power entry option.
6. MCA and MOCP values shown are inclusive of control power
transformer loads.
116
REC FUSE
MOCP
SIZE
372.0 600 600 500 450
206.0 350 350 250 250
196.1 300 300 250 250
170.1 250 250 225 200
137.2 225 225 175 175
210.3 350 350 300 250
200.2 300 300 250 250
193.0 300 300 250 250
181.7 300 300 225 225
428.2 700 700 600 600
237.3 400 400 300 300
224.8 350 350 300 300
195.5 300 300 250 250
157.2 250 250 200 200
242.8 400 400 300 300
231.4 400 350 300 300
223.0 350 350 300 300
210.4 350 350 300 250
445.3 700 700 600 600
247.5 400 400 300 300
234.8 400 400 300 300
203.8 350 350 250 250
164.0 250 250 200 200
253.2 400 400 350 300
241.5 400 400 300 300
232.9 400 350 300 300
218.6 350 350 300 300
217.3 500 350 450 300
207.3 500 350 400 250
179.2 450 300 350 225
143.5 350 225 300 175
222.8 500 350 450 300
212.7 500 350 400 300
204.3 500 300 400 250
192.9 500 300 400 250
327.8 500 500 400 400
311.0 500 500 400 400
270.0 450 450 350 350
217.1 350 350 300 300
334.8 500 500 450 400
319.0 500 500 400 400
307.7 500 500 400 400
289.4 500 450 350 350
339.0 500 500 450 400
322.2 500 500 400 400
279.8 450 450 350 350
224.6 350 350 300 300
346.0 500 500 450 450
329.0 500 500 400 400
317.7 500 500 400 400
299.4 500 500 400 400
CONTROL
CIRCUIT
Voltage MCA
1 PH, and
60 Hz MOCP
115 40
115 40
115 40
115 40
115 40
115 40
115 40
115 40
115 40
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60
115 60