Chiller Settings - Trane Tracer AdaptiView User Manual

E E q q u u i i p p m m e e n n t t S S e e t t t t i i n n g g s s
3. Touch S S a a v v e e to complete the change. The current value is updated in the upper left side of the

Chiller Settings

The following table lists the settings that are available as buttons on the Chiller Settings menu
screen, along with their corresponding setting options. The chiller configuration determines
which of the settings appear.
Table 8. Chiller Settings menu screen: Buttons and available setting options
Setpoint Source
BAS/Ext/FP
Ext/FP
Front Panel
Front Panel Control Type
Cooling/ Heating
Front Panel Ice Building Command
Auto/On
Front Panel Current Limit Setpoint
XXX.X %
Differential to Start
XX.X °F/C
Condenser Water Pump Off Delay
XX Min
Power-Up Start Delay
XXX Sec
42
– When you enter a new number, the value in the N N e e w w v v a a l l u u e e field is deleted and
replaced with the new entry.
– The backspace (arrow) key deletes the characters you previously entered.
– If the keypad is used to enter a setpoint that is out of range, an error dialog will
appear when you touch the S S a a v v e e button.
– Keypads that allow negative numbers have positive and negative number (+/-)
keys.
screen, demonstrating that the change has been communicated to the Tracer UC800
controller. The screen you were previously viewing appears.
N N o o t t e e : : Manual Control Settings screens have Apply buttons in addition to Save buttons. For
an example, refer to
touching Save, except that you remain at the current screen after the change is
communicated to the Tracer® UC800 controller.
Front Panel Chilled Water Setpoint
XX.X °F/C
Front Panel Ice Termination Setpoint
XX.X °F/C
Front Panel Base Loading Setpoint
XXX.X %
Differential to Stop
XX.X °F/C
Evaporator Water Pump Off Delay
XX Min
Starter Power Demand Time Period
XXX Min
"Manual Control Settings," p.
Page 1 of 2
Page 2 of 2
47. Touching Apply is the same as
Front Panel Hot Water Setpoint
XXX.X °F/C
Ice to Normal Cooling Timer Setpoint
XX Min
Front Panel Base Loading Command
Auto/On
Front Panel Free Cooling Command
Auto/On
Evap Low Water Flow Warning
SetpointXXXX.X gpm/lpm
CTV-SVU01G-EN