3.3.3
Selecting the
Language for the
Display
3.3.4
Adjusting the
Contrast
3.3.5
Inverter Manual
Start-Up Mode
86-160310-00
Installation and Users Manual
The English language is used by default. Other languages
available are:
•
French
•
Spanish
•
German
•
Italian
•
Dutch
To select a language:
•
Press the SHIFT key until the following is displayed on
the alphanumeric display.
ENGLISH
•
Each successive press of the SHIFT key changes the
language used by the Comet.
•
Press the ENTER key to confirm the display language.
•
Press any other key to cancel the modification.
After selecting the display language, you will be asked to set
the contrast:
CONTRAST
•
Each successive press of the SHIFT key alters the
contrast of the display.
•
Press the ENTER key to confirm the contrast.
•
Press any other key to cancel the modification.
Typically, the Inverter is configured for automatic start-up
mode. For manual start-up mode configuration, contact MGE
Customer Support Services.
For manual start up:
•
Press the green "Inverter ON" pushbutton.
•
The green "Load Protected" LED flashes.
•
The Inverter starts and if the transfer conditions are
correct, the load is transferred to the Inverter.
•
The red "Load Not Protected" LED goes off.
•
The green "Load Protected" LED goes on.
•
The alphanumeric display reads:
LOAD PROTECTED
Operation
3 — 7