AEG BSE577221M User Manual page 41

Problem
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
The food sensor does not
operate.
Steam and condensation
settle on the food and in the
cavity of the oven.
The display shows "C2".
The display shows "C3".
The display shows "F102".
The display shows an error
code that is not in this table.
There is water inside the
oven.
Possible cause
The door is not closed cor-
rectly.
The fuse is blown.
The lamp is defective.
The plug of the food sensor
is not correctly installed into
the socket.
You left the dish in the oven
for too long.
You want to start the Pyroly-
sis or Defrost function, but
you did not remove the food
sensor plug from the socket.
The cleaning function does
not operate. You did not
fully close the door, or the
door lock is defective.
• You did not fully close
the door.
• The door lock is defec-
tive.
There is an electrical fault.
There is too much water in
the tank.
ENGLISH
Remedy
Fully close the door.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
Replace the lamp.
Put the plug of the food sen-
sor as far as possible into the
socket.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
Remove the food sensor
plug from the socket.
Fully close the door.
• Fully close the door.
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows
"F102" again, contact the
Customer Care Depart-
ment.
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows the
error code again, contact
the Customer Care De-
partment.
Deactivate the oven and
wipe the water with a cloth
or sponge.
41