Service Interval; External Applications; External Exhaust Flap; Additional Fan - Miele PDR 914 SOM Operating And Installation Instructions

en - Supervisor level
You can adjust this reminder:
- Time interval of 5–55 hours
- Factory default: after 55 hours
- Off

Service interval

The tumble dryer shows a custom message at a selected interval to prompt you to under-
take specific maintenance tasks.
Three different messages can be created: 1/2/3. Each message is created in the language
and alphabet of the current supervisor language.
Your message is displayed at the end of the programme and can be acknowledged with
The same message appears at the end of the next programme.
Settings
This setting allows you to determine the interval (by hours or date) at which the message
appears.
- Factory default: Off
- By time
You can then select a time interval from 1–9999 hours.
- By date
You can enter a date.
Message text
Enter your message for your planned maintenance work. You can edit one, two or all three
of the 1/2/3 messages.
Reset display
The message appears until the display is permanently reset. The message then appears
again once the next interval is reached.

External applications

External exhaust flap

External hardware is connected via the Miele Connector Box.
The time delay between the external exhaust air flap's activation point and the switch-on
time for the drum/fan motor is regulated.
A message appears in the display while the exhaust air flap is open.
- Factory default: off
This option must always be selected if there is no exhaust air flap to activate. This pre-
vents the programme from being cancelled.
- On (1 second to 5 minutes)

Additional fan

External hardware is connected via the Miele Connector Box.
86
Clean the filters
.
OK