Setting Up A Z System - PI L-406 Series User Manual

5 Installation
3. Fix the L-406 to the mounting hole made accessible on the lower L-406: Tighten the
screw in the mounting hole completely.
4. Repeat steps 2 and 3 for the other mounting holes required in the base body of the
upper positioner.
5. Check that the upper positioner is firmly seated.
5.5.3

Setting Up a Z System

NOTICE
Excessively long screws!
Screws and locating pins inserted too deeply can damage the lower positioner.
 Pay attention to the depth of the mounting holes in the motion platform (p. 46) of the
lower positioner.
 Only use screws and locating pins of the correct length for the respective mounting holes.
Designations in these instructions:
Lower positioner: X axis in an XZ combination; Y axis in an XYZ combination. The

positioner that the upper positioner is mounted on with an adapter bracket.
Upper positioner: Forms the Z axis of the multi-axis system, is mounted in a vertical

alignment to the lower positioner with an adapter bracket.
L-406 Compact Linear Stage MP150E Version: 1.1.0 25