Download Print this page

Advertisement

Quick Links

1 0 5 . 7 5 5
" S t i l e t t o "
Please Note
The OPITEC range of projects is not primarily intended
as toys for young children. It is for teaching, designing
and making to ensure that pupils experience a range of
tools and processes.
D105755#1
1

Advertisement

loading
Need help?

Need help?

Do you have a question about the Hobbyfix Stiletto 105.755 and is the answer not in the manual?

Questions and answers

Summary of Contents for Opitec Hobbyfix Stiletto 105.755

  • Page 1 ” S t i l e t t o ” Please Note The OPITEC range of projects is not primarily intended as toys for young children. It is for teaching, designing and making to ensure that pupils experience a range of tools and processes.
  • Page 2: Product Information

    1. Product information: Article: Simple glider suitable for hand and tow line launching. Use: In open space with light or no wind conditions 2. Material information: 2.1 Materials: Pine, balsa, plywood, beech Working: Sawing, shaping and sanding Joining: PVA white glue or similar Finish: Use varnish or paint to decorate ( sparingly) 2.2 Materials:...
  • Page 3: Planning Overview

    4. P ARTS LIST Part No. Quantity Description Material / Size mm Fuselage Poplar plywood 3x 200 x 400 see pattern Fuselage part Poplar plywood 3x 200 x 400 see pattern Fuselage part Poplar plywood 3x 200 x 400 see pattern Fuselage part Poplar plywood 3x 200 x 400...
  • Page 4 5.1 Making the parts for the fuselage 5.1.1 Glue together the fuselage pattern side parts 1 (page 7) on the lines shown on the pattern and the trace or cut out the contour of the two side parts and the formers 2-4 (See page 11) and the strengt- heners 5 and 6 (See page 11) on to the plywood sheet 3 x 200 x 400 (Study the cutting plan carefully!! You can glue the patterns onto the plywood or draw around them ) Work with care!!! The formers 2-6 must be all the same width ( 20m ) this important.
  • Page 5 5.2.2 Round off all the edges on the tail and fin EXCEPT those where the tail fin joins the tail plane. The best way to do this is lay the parts flat on your working board and then slide the parts over the edge of the board and then sand them round 5.2.3 Glue the tail fin in the middle of the tail plane making sure that it is upright ( use a set Square) Use pins to hold it place until the glue has set...
  • Page 6: Your First Flight

    –careful as it will break easily!). Tow Line: For a towline you should look in the Opitec catalogue The tow line start is similar to launching a kite You will need two people, one to hold the model and one to run...
  • Page 7 Cutting pattern for the plywood sheet Patterns for the sides 1 cut here cut here D105755#1...
  • Page 8 D105755#1...
  • Page 9 135,0 Randbogen 19...
  • Page 10 D105755#1...
  • Page 11 20,0 20,0 20,0...
  • Page 12 D105755#1...
  • Page 13 130,0 cut here D105755#1...
  • Page 14 D105755#1...
  • Page 15 cut here Trennlinie D105755#1...
  • Page 16 D105755#1...
  • Page 17 37,0 137,0 222,0...