Table of Contents
Advertisement
Note: Use clip nuts if your rack has round holes. If your rack has square holes, you can
use the cage nut insertion tool or a flat-blade screwdriver to install cage nuts.
3 On the rail marked "R", loosen the two adjustment screws on the inside of the rail and
adjust the length of the rail to the depth of your rack.
Rear black
hex screws
Adjustment
screws
4 Hold the rail against the outside of the right mounting flange on the rack and loosely
insert the two front black hex screws.
5 Extend the rail outside of the rear mounting flange on the rack; then, install and tighten
the two rear black hex screws.
6 Tighten the two front black hex screws; then, tighten the adjustment screws on each
rail.
7 Repeat
Step 3
16
IBM Netfinity FAStT500 RAID Controller Enclosure Unit Installation Guide
Cage
nut
through
Step 6
to install the rail marked "L" on the left side of the rack.
Clip
nut
Front black hex
screws
Advertisement
Table of Contents
