Table of Contents
Advertisement
If the blade is not an exact 45° (Fig. 37c-37d):
•
Unlock the bevel locking lever .
•
Loosen the 45° set screw (located at the right of the
bevel track on the front) with 4 mm hex key (not
supplied).
•
Place a triangle square (not provided) beside the
blade on the left. The edge of the square and the saw
4
blade should be parallel.
NOTICE: Make sure that the square contacts the at part of
the saw blade, not the blade teeth.
•
Lock the bevel locking lever .
•
Tighten the 45° set screw . Check again for squareness
and continue to adjust if needed.
•
If needed, adjust the bevel indicator to 45°.
•
Make a test cut.
Fig. 37c
6
Fig. 37d
5
Adjusting the blade parallel to the miter
gauge groove (Fig. 38a-38c)
WARNING: The blade must be made parallel to the
miter gauge groove so the wood does not bind
resulting in kickback. Failure to do so could result in
serious personal injury.
Do not loosen any bolts for this adjustment until you have
checked with a ruler and made test cuts to be sure
adjustments are necessary. Once the bolts are loosened,
these items must be reset.
1
5
6
1
5
4
10
1
10
•
Turn saw o and unplug saw.
•
Remove the blade guard and anti-kickback pawls.
•
Place the riving knife in "down" position.
•
Raise the blade by turning the height adjusting handle.
•
Mark beside one of the blade teeth at the front of the
blade . Using a ruler (not included), measure the
1
distance from the inside face of the blade tooth to the
left edge of the right miter gauge groove .
NOTICE: For greater accuracy, place the marked blade tooth
on top of the ruler.
•
Turn the blade so the marked tooth is at the back.
•
Move the ruler
distance from the inside face of the blade tooth to the
left edge of the right miter gauge groove . If the
distances are the same, the blade and the miter gauge
groove are parallel.
•
Place the riving knife in "uppermost" position.
•
Replace blade guard and anti-kickback pawls.
Fig. 38a
2
9
8
7
6
5
4
3
2
Fig. 38b
2
9
8
7
6
5
4
3
2
2
1
to the rear and again measure the
2
3
1
1
0
0
1
2
3
4
1
3
1
0
0
1
2
3
4
ENGLISH
3
3
5
6
7
8
9
10
5
6
7
8
9
10
29
Hide quick links:
Advertisement
Table of Contents
