Table of Contents
Advertisement
ENGLISH
Ensure the locking handle secures the rip fence in place. If
adjustment are needed, see "To check the tightness of the
rip fence locking handle" in the adjustment section.
Fig. 11
1
3
Miter gauge installation (Fig. 12)
The miter gauge
can be installed on each miter gauge
1
groove
on either side of blade.
2
•
Slide the guide rail
3
the guide grooves
of the saw table intended for this
2
purpose.
Fig. 12
3
1
To store the table saw accessories
(Fig. 13a-13b)
•
The table saw has two convenient storage areas (one on
either side of the saw) speci cally designed for the saw's
accessories: rip fence
stick
, anti-kickback pawls
3
guard
and blade wrenches
6
•
When not in use, unplug the saw and store accessories
securely.
16
of the miter gauge
into one of
1
2
2
, sub fence assembly
1
2
, miter gauge
4
5
.
7
Fig. 13a
2
3
Fig. 13b
4
Connect to a dust collection system
(Fig. 14)
The dust extraction port
diameter is located on the rear of the table saw. This port
can be connected directly to a dust collection system by
connecting the pick up end of the dust collection hose to
the dust port.
NOTICE: Care should be taken to position hoses to not
interfere with cutting operation.
CAUTION: It is strongly recommended to connect a
dust collection system to the dust extraction port.
WARNING: Table saw must be regularly checked for
dust built up and cleaned frequently, otherwise there
is a risk of heat built up and potential re.
Fig. 14
, push
, blade
1
5
7
with a standard 2 1/2" (63.5mm)
1
1
2
6
Hide quick links:
Advertisement
Table of Contents
