•
Turn saw off and unplug saw.
•
Set the blade angle to 0°.
•
Raise the saw blade to maximum height by turning
height adjustment handle clockwise.
•
Lock the blade by turning bevel locking lever clockwise.
•
Place the riving knife in the uppermost position.
•
Pull out and hold knob
. Align slot in anti-kickback
1
pawls
over the slot
marked of riving knife . Place
2
3
4
the spring pin
on the anti-kickback pawls
into the
5
2
slot
marked on the riving knife
.
4
3
•
Press on anti-kickback pawls assembly down until it
snaps into place and release knob
to insert the pin
1
6
into hole
marked on the riving knife
.
4
7
CAUTION: Pull up on anti-kickback pawls assembly
to make sure it is secured to riving knife.
WARNING: Gently pull up the anti-kickback pawls
assembly to ensure it is locked into place. Make sure
that the anti-kickback pawls move freely and are not
stuck in the table insert slot.
WARNING: Use extra caution when cutting wood
products having slippery surfaces as the anti-kickback
pawls may not always be e ective.
Fig. 9
5
5
6
1
2
3
7
4
Blade guard installation (Fig. 10a-10b)
WARNING: KEEP GUARDS IN PLACE and in good
working order for all through cut operations. Reinstall
the blade guard immediately after nishing any non-
through cut operations which require removal of the
blade guard. Failure to heed this instruction could
result in serious personal injury.
WARNING: Always install the blade guard onto the
riving knife in the uppermost position to provide
proper blade coverage. Installing the blade guard
onto the riving knife in any other position will prevent
them from working as designed, which could increase
the risk of serious personal injury.
•
Turn saw off and unplug saw.
•
Pull out the knob
on the blade guard and place the
1
pins
on the blade guard
into the slots
2 3
4
5 6
marked on the riving knife
.
7