Craftsman CMXETAX69434502 Instruction Manual page 13

ENGLISH
Fig. 4c
3
1
• Place front angle plate between leg assembly on right
side. Repeat with back angle plate
Carefully align holes in legs and angle plate.
Fig. 4d
4
• Install stand bolts through holes and tighten stand
6
bolts and hex nuts securely.
7
CAUTION: DO NOT overtighten. Stand should fold
and unfold smoothly.
Fig. 4e
6
• Place the stand on level ground and open to its fully
extended position.
12
2
2
2
2
4
on left side.
5
5
7
7
Fig. 4f
Mounting the table saw to the stand
(Fig. 5)
WARNING: Lower the blade to lowest position before
mounting saw.
WARNING: Do not t the saw without help. The saw
is heavy. Hold it close to your body. Keep your knees
bent and lift with your legs, not your back. Ignoring
these precautions can result in back injury.
• Position the table saw onto the stand so that holes in
the saw's frame are aligned with the holes in the stand's
brackets.
NOTICE: When positioning stand, make sure each leg is
spread fully outward to ensure stability.
NOTICE: Make sure the table saw's frame is ush against the
stand and that all the legs are touching the ground.
6
• Install carriage bolts
and frame. Secure with wing nuts
securely.
• Be sure the table saw is on level ground and the stand is
sturdy before use.
• If the saw wobbles, adjust leveling foot
balanced.
NOTICE: Turning clockwise will lower leveling foot. Turning
counterclockwise will raise leveling foot.
WARNING: Ensure all four bolts are present and
properly fastened. Do not use saw if any bolts are
missing or damaged. If missing or damaged, Call
1-888-331-4569 for replacement hardware.
through the holes in the brackets
1
and tighten
2
until stand is
3