Download Print this page

Craftsman CMXETAX69434502 Instruction Manual page 29

10"
Hide thumbs

Advertisement

Table of Contents
ENGLISH
Dust collection (Fig. 36)
This saw features a dust chute for convenience in
discharging sawdust. A standard utility vacuum can be
attached to the dust extraction port on dust chute ,
located under the back side of the saw cabinet.
During periods of extended use, the dust chute should be
emptied and cleaned to prevent buildup of sawdust and to
make sure there are no obstructions that could hinder
maximum performance.
CAUTION: It is strongly recommended to connect a
dust collection system to the dust extraction port.
WARNING: Table saw must be regularly checked for
dust built up and cleaned frequently, otherwise there
is a risk of heat built up and potential re.
To clean the dust chute:
Turn saw o and unplug saw.
Loosen the screw at the left side of the dust chute .
3
Open the small ba e .
Shake out any sawdust and wipe with a clean dry cloth,
as needed.
Replace the small ba e and securely tighten the
screw .
3
Fig. 36
4
ADJUSTMENTS
WARNING: Before performing any adjustment, make
sure tool is unplugged from power supply and switch
is in o position. Failure to do so could result in serious
personal injury.
WARNING: Make sure the blade guard is reinstalled
immediately after making any adjustment which
requires it to be removed. Failure to heed this
instruction could result in serious personal injury.
28
1
2
4
4
1
2
3
To set the blade at 0° and 45°
(Fig. 37a-37d)
This saw has positive stops that will quickly position the saw
1
blade at 90° (0°) or 45° to the table. Angle settings of saw
have been set at the factory and, unless damaged in
shipping, should not require setting during assembly. After
extensive use, they may need to be checked.
Turn saw o and unplug saw.
Raise the blade to the maximum height by turning the
height adjusting handle clockwise.
Remove the anti-kickback pawls and blade guard.
If the blade is not perfectly vertical (0°) (Fig. 37a-37b):
Unlock the bevel locking lever .
Loosen the 0° set screw (located at the left of the
bevel track on the front) with 4 mm hex key (not
supplied).
Place a framing square (not supplied) beside the
1
blade on the right. The edge of the square and the
4
saw blade should be parallel.
NOTICE: Make sure that the square contacts the at part of
the saw blade, not the blade teeth.
Lock the bevel locking lever .
Tighten the 0° set screw . Check again for squareness
and continue to adjust if needed.
Fig. 37a
4
Fig. 37b
2
1
2
3
1
2
1
3

Hide quick links:

Advertisement

Table of Contents
loading

  Related Manuals for Craftsman CMXETAX69434502