Table of Contents
Advertisement
Data Hold
To freeze the LCD reading, press the HOLD button. The HOLD icon appears on the LCD.
Press the HOLD button again to return to normal operation.
Relative
Press the REL button (REL will appear in the display) to zero the reading and create a
reference point. All future reading will be the difference between the actual reading and the
stored "REL" reading. In the REL mode, autoranging is disabled and measurements are
limited to the range active when the REL button was pressed. Press the REL button to exit
the mode.
Note: Relative does not function in Frequency or Duty Cycle mode.
Automatic Power Off
In order to conserve battery life, the meter will automatically turn off after approximately 30
minutes. To turn the meter on again, change the position of the function switch.
Low battery indication
When the
icon appears in the display, the battery should be replaced. Refer to the
battery replacement procedure in the maintenance section.
8
MA410 V2.2 08/08
Advertisement
Table of Contents
Need help?
Do you have a question about the Extech Instruments MA410 and is the answer not in the manual?
Questions and answers