FLIR Extech Instruments MA410 Manual page 11

General Specifications
Clamp jaw opening
Display
Continuity check
Diode test
Low Battery indication
Over-range indication
Measurement rate
Thermocouple sensor
Input Impedance
AC bandwidth
AC response
Operating Temperature
Storage Temperature
Operating Humidity
Storage Humidity
Operating Altitude
Battery
Auto power OFF
Dimensions & Weight
Safety
Approvals
Technical support: Extension 200; E-mail: support@extech.com
Repair & Returns: Extension 210; E-mail: repair@extech.com
Product specifications subject to change without notice
For the latest version of this User's Guide, Software updates, and other
up-to-the-minute product information, visit our website: www.extech.com
Copyright © 2008 Extech Instruments Corporation (a FLIR company)
All rights reserved including the right of reproduction in whole or in part in any form.
1.18" (30mm) approx.
4,000 count LCD
Threshold <150Ω; Test current < 0.5mA
Test current of 0.3mA typical;
Open circuit voltage [ 1.5VDC typical
Battery symbol is displayed
'OL' display
2 readings per second, nominal
Type K thermocouple required
10MΩ (VDC and VAC)
50 to 400Hz (VAC)
Average responding
41°F to 104°F (5°C to 40°C)
-4°F to 140°F (-20°C to 60°C)
Max 80% up to 87°F (31°C) decreasing linearly to 50% at
104°F(40°C)
<80%
7000ft. (2000meters) maximum.
Two "AAA" 1.5V batteries
After approx. 30 minutes
7.9x2.6x1.5" (200x66x37mm); 7.23oz. (205g)
For indoor use and in accordance with the requirements for
double insulation to IEC1010-1 (2001): EN61010-1 (2001)
Overvoltage Category III 600V, Pollution Degree 2.
CE,
Support line (781) 890-7440
11 MA410 V2.2 08/08