H3C S3600 Series Operation Manual page 163

Operation Manual – Port Basic Configuration
H3C S3600 Series Ethernet Switches-Release 1510
1.2.10 Enabling the System to Test Connected Cable
You can enable the system to test the cable connected to a specific port. The test result
will be returned in five seconds. The system can test these attributes of the cable:
Receive and transmit directions (RX and TX), short circuit/open circuit or not, the length
of the faulty cable.
Table 1-12 Enable the system to test connected cables
Enter system view
Enter Ethernet port view
Enable the system to test
connected cables
1.2.11 Configuring the Interval to Perform Statistical Analysis on Port Traffic
By performing the following configuration, you can set the interval to perform statistical
analysis on the traffic of a port.
When you use the display interface interface-type interface-number command to
display the information of a port, the system performs statistical analysis on the traffic
flow passing through the port during the specified interval and displays the average
rates in the interval. For example, if you set this interval to 100 seconds, the displayed
information is as follows:
Last 100 seconds input:
Last 100 seconds output:
Table 1-13 Set the interval to perform statistical analysis on port traffic
Enter system view
Enter Ethernet port view
Set the interval to perform
statistical analysis on port
traffic
1.2.12 Enabling Giant-Frame Statistics Function
The giant-frame statistics function is used to ensure transmission of network traffic and
to facilitate statistics and analysis of unusual traffic on the network.
Operation
system-view
interface
interface-number
virtual-cable-test
0 packets/sec 0 bytes/sec
Operation
system-view
interface
interface-number
flow-interval interval
Command
interface-type
0 packets/sec 0 bytes/sec
Command
interface-type
1-11
Chapter 1 Port Basic Configuration
Remarks
—
—
Required
Description
—
—
Optional
By default, this interval is
300 seconds.