H3C S3600 Series Operation Manual page 704

Operation Manual – Mirroring
H3C S3600 Series Ethernet Switches-Release 1510
1.3.3 Configuring RSPAN
I. Configuration prerequisites
The source switch, intermediate switch, and the destination switch are
determined.
The source port, the reflector port, the destination port, and the remote-probe
VLAN are determined.
Layer 2 interoperability is ensured by configuration between the source and
destination switches over the remote-probe VLAN
The direction of the packets to be monitored is determined.
The remote-probe VLAN is enabled.
II. Configuring RSPAN on the source switch
Table 1-9 Configure RSPAN on the source switch
Enter system view
Create a VLAN and enter
the VLAN view
Define the current VLAN
as the
VLAN
Exit the current view
Enter the port view of the
port that connects to the
intermediate
destination switch
Configure the current port
as Trunk port
Configure Trunk port to
permit packets from the
remote-probe VLAN
Exit current view
Configure
source mirroring group
Configure a source port
for remote mirroring
Operation
system-view
vlan vlan-id
remote-probe
remote-probe
enable
quit
interface
switch or interface-number
port link-type trunk
port trunk permit vlan
remote-probe-vlan-id
quit
a remote mirroring-group group-id
remote-source
mirroring-group group-id
mirroring-port
mirroring-port-list { both |
inbound | outbound }
Chapter 1 Mirroring Configuration
Command
vlan
interface-type
1-10
Description
—
vlan-id is the ID of the
remote-probe VLAN to be
defined.
Required
—
—
Required
By default, the port type is
Access.
Required
This setting is required for
the source switch port
that connects to
intermediate switch
destination switch.
—
Required
Required
the
or