Sun Microsystems Fire V1280 Product Notes page 6

FIGURE 3
2. Power down the system.
Refer to the system service manual for your system for a safe procedure to halt the
operating system and put the system into standby mode.
3. Extend the cabinet stabilizer and lock it in position (as applicable).
Note – For supplemental details about this step and other steps in the rest of this
procedure, refer to the system installation guide for your system.
4. Disconnect the I/O and power cables attached to the system.
5. Remove the cable management arm from the back of the system (as applicable).
6. (Optional) remove the front bezel doors.
This protects the doors from potential damage during the move.
a. Open the door and press down on the hinge pin levers to release the hinges.
b. Lift the door off the hinge pins and store the door in a safe place.
c. Repeat Step a and Step b for the second front bezel door.
7. For a Sun Fire V1280 system, loosen the captive screws that hold the front of the
system to the cabinet.
8. If locking nuts and retention washers are installed (
store for future use.
4 Sun Fire V1280/Netra 1280 Systems Product Notes • March 2004
FRONT
Slide Cutouts
(The shipping cradle drawing has been simplified
to show only the details of the slide cutouts)
FIGURE 1
), remove them and