Table of Contents
Advertisement
General
Protective devices
1.5 Intended use
General
Changes and modifica-
tions at the product
1.6 Responsibility of the user
General
1.7 Protective devices
Protection
12
The product is exclusively designed and constructed for the intended use described in
this manual. The product is intended used if all the notes and information of this manual
are considered.
WARNING!
Danger by not intended use!
Each use of the product, which differs to the intended use can lead to
dangerous situations.
Therefore
n
Use the product only intended.
n
Use the product only together with the recommended components.
n
Consider all the data in this manual.
n
Ensure that only qualified personnel work with/at the product.
of the personnel' page 13
n
Ensure during configuration that the product is operated within its specifications.
n
Ensure that the power supply corresponds to the given specifications.
n
Only use the product in a technically perfect condition.
n
Only use the product in combination with approved components.
n
Only use the product in an area of second type (industrial area). The product was
developed such as this fulfils the requirements of the category C3. For operation an
approved power supply (SELV/PELV) is necessary. Here With the usage of the
product in an area of first type, category C2/C1 (living-, business and trade without an
interstage transformator directly at a public low-voltage-system) the cabinet builder
has to reduce the emission (conducted and radiated) by special measure steps,
which are to be demonstrated, since it can come without any additional measures to
EMC disturbances. Whether a products described here reaches category C2/C1 with
additional measures, cannot be ensured.
To avoid endangerments and to ensure the optimal power neither changes nor modifica-
tions may be made at the product, which are not specially approved by the manufacturer.
The product is used in the commercial range. The user of the product is subject of the
statutory duties to work safety. In addition to the safety instructions in this manual, for the
usage environment of the product valid safety, accident prevention and environmental
protection regulations must be adhered.
The user must be informed about the valid industrial safety regulations and determine
n
in an endangerment evaluation additionally dangers, which arise as a result of the
special conditions for the product on the place of operation. This is to be transcribed
with working instructions for the operation of the product.
n
These working instructions must be kept in direct environment of the product and
accessible at any time for people, which work with the product.
n
The working instructions must fully be adhered.
n
The product is only to be operated in a technically flawless condition.
The place of installation of the safe field bus modules must comply for devices according
to IP20.
VIPA System SLIO
Ä Chap. 1.8 'Education
HB300 | SM-S | 02x-1SD10 | en | 20-02
Advertisement
Table of Contents
