Table of Contents
Advertisement
VIPA System SLIO
Accessories
2.1.1 Hardware revision
Hardware revision on the
front
Hardware revision via web
server
HB300 | SM-S | 02x-1SD10 | en | 20-02
Shield bus carrier
The shield bus carrier serves to carry the shield bus (10mm x 3mm) to connect cable
shields. Shield bus carriers, shield bus and shield fixings are not in the scope of delivery.
They are only available as accessories. The shield bus carrier is mounted underneath the
terminal of the terminal module. With a flat mounting rail for adaptation to a flat mounting
rail you may remove the spacer of the shield bus carrier.
Bus cover
With each bus coupler, to protect the backplane bus connectors, there is a mounted bus
cover in the scope of delivery. You have to remove the bus cover of the bus coupler
before mounting a System SLIO module. For the protection of the backplane bus con-
nector you always have to mount the bus cover at the last module of your system again.
If this is a clamp module, for adaptation the upper part of the bus cover can be cut off.
The hardware revision version is printed on every System SLIO module.
n
n
Since a System SLIO module consists of a terminal and electronics module, you will
find a hardware revision on each of them.
n
Authoritative for the hardware revision of a System SLIO module is the hardware revi-
sion of the electronic module. This is always located under the labeling strip of the
corresponding electronic module.
n
On modules without labeling strip, such as CPUs, the hardware revision is printed on
the front.
The example here shows the hardware revision 1.
1 is marked with 'X' .
On the CPUs and some bus couplers, you can output the hardware revision 'HW
Revision' via the integrated web server.
Product description
System conception > Hardware revision
25
Advertisement
Table of Contents
