Table of Contents
Advertisement
Deployment
Installation guidelines
Installation and wiring dia-
gram
Determining the device
parameters
Sequence of the phase of
planning
3.2 Installation guidelines
General
What does EMC mean?
Possible interference
causes
68
In the phase of planning an installation and a wiring diagram for the total safety system
are to be created. It contains all system components and their wiring.
CAUTION!
Please consider a separation of high- and low-voltage signals in the
installation and wiring diagram for the exclusion of cross- or short circuits
to potentials > 60V.
This can be achieved for the System SLIO by a separate installation and
appropriate isolation.
With the production of the wiring diagram valid standards and guidelines
are to be considered for the proper installation of lines.
The available safety parameters can be found in the chapter "Product description"
Ä Chap. 2 'Product description' page 22.
The parameters of further standard modules can be found in the according user manual.
CAUTION!
In the phase of planning a list of parameters to be adjusted is to be cre-
ated with a determination of the individual parameters and their verifica-
tion.
The system is planned according to the respective need of the plant or machine. The
components available for the control technology are more described at "Installation" fur-
ther down. Before the commissioning of a module the following must be checked and
ensured:
n
Compatibility of the modules (
data).
n
Sufficient supply of the control system by attached power supplies, respectively
attached safety components.
The installation guidelines contain information about the interference free deployment of
the System SLIO. There is the description of the ways, interference may occur in your
PLC, how you can make sure the electromagnetic compatibility (EMC), and how you
manage the isolation.
Electromagnetic compatibility (EMC) means the ability of an electrical device, to function
error free in an electromagnetic environment without being interfered respectively without
interfering the environment.
All System SLIO components are developed for the deployment in industrial environ-
ments and meets high demands on the EMC. Nevertheless you should project an EMC
planning before installing the components and take conceivable interference causes into
account.
Electromagnetic interferences may interfere your control via different ways:
n
Electromagnetic fields (RF coupling)
n
Magnetic fields with power frequency
n
Bus system
Ä Chap. 2.12 'Compatibility list' page 64 and technical
HB300 | SM-S | 02x-1SD10 | en | 20-02
VIPA System SLIO
Advertisement
Table of Contents
