Window Kit Installation; Exhaust Hose Installation - Arctic King AKPD-12CR4 Owner's Manual

Fig.16a
Fig.16b
Fig.17a
Hole seat Hole seat
Hook
Hook
Fig.17b
Push
Fig.18
CLOSE
OPEN
Fig.19

Exhaust hose installation:

The exhaust hose and adaptor must be installed or removed
in accordance with the usage mode.
COOL,HEAT(heat pump type) or AUTO
mode
FAN,DEHUMIDIIFY or HEAT(electrical heat type)
mode
1. Install the adaptor B and adaptor I onto the exhaust hose as
shown in Fig.16a or Fig.16b. Refer to the previous pages for

window kit installation.

2. Install the flexible Exhaust hose as depicted in Fig.17a&b.
Then push the hook of the Exhaust hose into the hole seat
of the unit in Fig.18.
Hook
CAUTION:
Make sure that there is no obstacle around the air outlet of
the exhaust hose (in the range of 500mm) in order to the
exhaust system works properly.
Push
VENT CONTROL feature
The Vent Control is located at the back of the air conditioner.
The OPEN position removes stale air from the room and
exhausts it to the outside. Fresh air is drawn in through normal
passages in the home.
When not need to circulate the room air, set Vent Control to
CLOSE position.
INSTALLATION INSTRUCTIONS
Install
Remove
12