Recovery Mode; Fault Code Description - Sunny Health & Fitness CARBON PREMIUM AIR MAGNETIC User Manual

RECOVERY MODE

During use, first test your pulse as above mentioned. Then press "RECOVERY" key to enter pulse
recovery function. The display will show 1 minute count-down as well as your pulse rate. Then, it
will pop up your pulse recovery level from F1 to F6, which is from the fastest recovery to slowest.
The fastest recovery F1 shows the best.
F1=1.0
1.0 < F2 <2.0
2.0 < F3 <2.9
3.0 < F4 <3.9
4.0 < F5 <5.9
F6=6.0
WIRELESS PULSE
The computer supports the standard 5.3Khz wearing heart
rate detector.
1. Please wet the two electrodes of the heart rate detector.
2. Wear the heart rate detector on your chest.

FAULT CODE DESCRIPTION

FAULT CODE POSSIBLE CAUSE
The motor doesn't work.
There
E1
wrong with the cables.
The computer cannot
supply normal voltage to
the motor.
Hands aren't put on the
two
immediately
pressing START.
E2
Body
cannot
signal for pulse.
NOTE:
1. This computer uses a 9V/1A power adapter.
2. When the computer is abnormal, please pull out the power plug and re-insert.
3. Without any operation, the computer will enter standby mode after five minutes.
RECOVERY
BEST STATE
WELL
GOOD
ORDINARY
Relatively poor
BAD
Check if the motor wires are
plugged in or check if the
motor is stuck.
is something Check if the cables are
damaged.
Test whether the voltage of
the motor is normal when
pressing UP and DOWN.
handle pulses
after
Far Function Check if the pulse is working
receive the when
program.
CHECK
not in Body
17
TIMER 60"
SOLUTION
Pulse in the cable again or
change the motor.
Change the cables or plug
in again.
Change the computer.
Put the hands on the two
handle pulses immediately
after pressing START.
Fat Change the computer.
Version 1.1