Table of Contents
Advertisement
3. Shut off the engine and remove the key.
4. Empty the bags.
5. Unlatch the lower tube.
6. Remove the tubes from the bagger.
7. Use a stick or similar object, not your hands, to remove
and clear the obstruction from the tube assembly.
Note: In most cases, you can shake the debris out of
the tubes.
8. If the blower assembly is plugged, remove the plastic
belt cover, unlatch the bagger blower assembly, remove
the belt, and swing it open.
9. Use a stick or similar object, not your hands, to remove
and clear the obstruction from the blower assembly.
10. After you remove the obstruction, install the complete
bagger system and resume operation.
Removing the Bagger
WARNING
Components around the engine will be hot if
the machine has been running. Touching hot
components can cause burns.
• Do not touch engine components when hot.
• Allow engine to cool before removing the bagger.
CAUTION
Failing to remove the front bagger weights
and operating the machine without the bagger
attachment may cause an unstable condition which
could result in a loss of control.
Always remove the front weights when removing
the bagger attachment.
Remove the bagger by repeating the setup sections from the
Installation Instructions and Operator's Manual in reverse order.
Always remove the front baffles and front weights when
removing the bagger attachments.
Important: Install the side-discharge chute when you
remove the bagger and blower.
Note: It is only necessary to remove the cutoff baffle when
installing a mulching kit.
20
Advertisement
Table of Contents
