Table of Contents
Advertisement
Determine the left and right sides of the machine from the normal operating position.
1
Preparing the Machine
No Parts Required
Procedure
Perform the following procedure to prepare the machine for
attaching the blower and finishing kit.
1. Park the machine on a level surface.
2. Disengage the blade-control switch, engage the parking
brake, and move the motion-control levers outward to
the
-
NEUTRAL
LOCK
3. Shut off the engine and remove the key.
4. Ensure that the machine is secure from movement
before you begin to work on it.
5. Repair all bent or damaged areas of machine deck and
replace any missing parts.
6. Clean the machine of any debris on the machine deck
or rear part of the machine to ease installation.
position.
2
Installing the Weight
Parts needed for this procedure:
1
Weight tray
1
Left weight-tray mount
1
Right weight-tray mount
1
Suitcase weight—16 kg (35 lb)
1
Retaining rod
2
Bolt (3/8 x 1-1/4 inches)
4
Flange nut (3/8 inch)
2
Carriage bolt (3/8 x 1 inch)
2
Self-tapping bolt (5/16 x 3/4 inch)
Procedure
CAUTION
The bagger changes the weight distribution of the
machine. Operating the machine without the front
weights may cause an unstable condition, which
could result in a loss of control.
Ensure the front weights are properly installed
before operating the machine with the bagger
attachment.
1. Remove the existing bolt and nut from the left and
right side of the platform where you will install the
weight-tray mounts.
2. Use the 2 self-tapping bolts (5/16 x 3/4 inch), 2 bolts
(3/8 x 1-1/4 inches), and flange nuts (3/8 inch) to
secure the left and right weight-tray mounts to the
machine
(Figure
6
3).
Advertisement
Table of Contents
