Table of Contents
Advertisement
Cleaning the Bagger and
Bags
Service Interval: After each use
1. Wash the inside and outside of the bagger hood, bags,
tube, and the underside of the mower.
Note: Use a mild automotive detergent to remove dirt.
2. Make sure that you remove matted grass from all parts.
3. After washing all parts, let them dry thoroughly.
Note: With all parts installed, start and run the machine for
a minute to assist in drying.
Inspecting the Blower Belt
Service Interval: After the first 8 hours
Every 25 hours
Check belts for cracks, frayed edges, burn marks or any other
damage. Replace damaged belts.
Replacing the Blower Belt
1. Remove the plastic belt cover.
2. Pull back on the spring-loaded idler pulley to relieve
the belt tension
(Figure
Figure 34
1. Blower pulley
2. Blower in position (housing
portion removed for
illustrative purposes)
3. Drive pulley
3. Remove the existing bagger belt from the mower-deck
pulley.
34).
4. Mower deck
5. Idler/tension pulley
6. Blower belt
4. Remove the blower from the mower deck.
5. Remove the existing bagger belt from the blower
pulleys.
6. Install the new belt around the blower pulleys
34).
7. Install the blower onto the blower support.
8. Install the new belt around the mower-deck pulley
(Figure
34).
9. Pull back on the spring loaded idler pulley and install
the belt onto the spring-loaded idler pulley
g202246
23
(Figure
(Figure
34).
Advertisement
Table of Contents
