Table of Contents
Advertisement
Figure 26
1. Blower pulley
2. Blower in position (housing
portion removed for
illustrative purposes)
3. Spring
4. Idler-pulley post
2. Ensure that the belt remains aligneld to the blower
pulley while you are installing the blower assembly.
3. Pull the spring loaded idler pulley away from the fixed
spring post, and route the belt around the mower deck
pulley
(Figure
26).
Note: Ensure that the belt is routed around the blower
pulley correctly.
4. Route the belt around the drive pulley as illustrated in
Figure 25
and
Figure
5. Install the powered bagger cover over the belt cover,
and secure it by tightening the knob
Figure 27
1. Knob
2. Powered bagger cover
5. Idler arm
6. Drive pulley
7. Idler/tension pulley
8. Blower belt
26.
(Figure
27).
3. Belt cover
12
Installing the Discharge
Tubes
Parts needed for this procedure:
1
Upper tube
2
Screw (1/4 x 3/4 inches)
2
Washer (1/4 inch)
2
Locknut (1/4 inch)
1
Lower tube
g201513
Procedure
Important: Make sure that the mower deck is in the
lowest height-of-cut position before installing the
discharge tubes.
Note: Remember to install the grass deflector when you
remove the bagger from the mower.
1. Disengage the PTO and engage the parking brake.
2. Shut off the engine and remove the key.
3. Lower the mower deck to the lowest height-of-cut
position.
4. Remove the bags for viewing the tube under the hood.
5. Lower and latch the hood.
6. Use both latches to attach the lower tube to the blower
assembly
(Figure
Note: Ensure the notch in the lower tube is at the
bottom when installed
g201515
16
28).
(Figure
30).
Advertisement
Table of Contents
