Radius Corner Shelf - Schulte Classica Series Manual

Radius Corner Shelf

1. Position a level along the back wall, flush with the top
of one of the cabinets and make a pencil mark in the
corner.
2. Mount the Radius Corner Support in corner.
• Cut support as needed and align with pencil mark.
Keep cut end facing downward to assure proper hole
alignment.
• Secure the support to the wall with mounting screws
inserted through 3 of the predrilled holes at the top,
middle and bottom of the support.
• Avoid the uppermost hole, as this will receive a shelf
pin to support the top Radius Shelf and any other holes
in which a shelf pin is intended.
3. Place an uncut Radius Corner Shelf spanning the 2
Cabinets, then push the shelf into the corner.
• Make sure the front of the shelf is flush with the fronts
of the cabinets.
4. Standing beneath the shelf, mark cut lines on the
underside of the shelf where each of the cabinets meet
the shelf.
• Also mark a cut line at the back of the shelf to
accommodate Corner Shelf Support.
• Shelf pins for top and bottom should be placed in the
uppermost panel and support holes.
SCHULTE Classica Installation Training
(1-2)
(3-6)
Page 66