Operating Instructions; Glass Information; Window Frame Assembly Removal; Glass Cleaning - Vermont Castings Chateau DVT38 Installation Instructions And Homeowner's Manual

Chateau™

Glass Information

Only glass approved by CFM Specialty
Home Products should be used on this
fireplace.
•
The use of any non-approved replacement glass will
void all product warranties.
•
Care must be taken to avoid breakage of the glass.
•
Do not operate appliance with glass front
removed, cracked or broken.
•
A replacement glass frame assembly (complete
with gasket) is available through your Vermont
Castings, Majestic Products dealer and should
only be installed by a licensed qualified service
person.
Glass Frame Assembly Removal
1. Turn the fireplace OFF (including the pilot).
2. If the unit has been operating allow time for the
components to cool.
3. Using a Phillips screwdriver, unfasten two (2) screws
located at the top of the glass frame. (Fig. 35)
4. Tilt the glass frame at the top away from the unit.
Lift it carefully off the bottom door track and set on
padded surface.
Phillips
Screws
Fig. 35 Remove Phillips screws, tilt frame forward and lift off
bottom door track.
FP1363
20
DVT44
remove glass
5/03

Operating Instructions

FP1363

Glass Cleaning

It is necessary to periodically clean the glass. During
start-up, condensation, which is normal, forms on the
inside of the glass. This condensation causes lint,
dust and other airborne particles to cling to the glass
surface.
Also initial paint curing may deposit a slight film on
the glass. It is therefore recommended the glass be
cleaned two or three times with a non-ammonia based
household cleaner and warm water (gas fireplace glass
cleaner is recommended) within the first few weeks of
operation.
After the initial cleaning process the glass should be
cleaned two or three times during each operating
season depending on the environment in the house.
Clean the glass after the first two weeks of
operation.
Restrictor Plates Installation
Refer to Pages 13 & 16 for your venting configuration
and combination of restrictor plate requirement and
fresh air restrictor plate adjustment.

Restrictor Plate Installation

Using the two (2) screws provided along with the restic-
tor plate shipped with the logset, fasten the restrictor
plate to the firebox top through the front of the unit. (Fig.
36)
DVT38
Use tin snips to cut
along inner slots to
make 3" restrictor
plate. (Refer to
Page 13)
FP1364
Fig. 36 Restrictor plate location.
FP1364
restrictor plate
5/23/03 djt
Flue Opening
Restric-
tor Plate
Sheet Metal
Screws
DVT44
Use tin snips to cut
along slots to make 4¹⁄₂"
(114mm) restrictor plate.
(Refer to Page 13)
DVT38
Use tin snips to cut
along outer slots to
make 4¹⁄₂" (114mm)
restrictory plate.
(Refer to Page 16, Fig.
28)
20006081