Vermont Castings Bay Front Kits DV36/39 Installation Instructions

DV36/39 STKP and
CBTK
Bay Front Kits

Installation Instructions

Please read these instructions before beginning
assembly.
Caution
Porcelain enamel is fragile. The finish can be eas-
ily damaged if castings are not handled carefully.
Always place castings on a protective surface, such
as a towel, blanket or carpet.
Carefully unpack the Front Face components and in-
spect for damage. Report missing or damaged parts to
your dealer immediately.
Kit Contents
•
Upper Grille Assy.
•
Window Assy.
•
Hanger Brackets, 2
•
Knob Ext., Philostat
•
Knob, Off/On Ext. SIT#916.188
•
Knob, HI/LO Ext., SIT#916.189
•
#10 x 1/2" sheet metal screws, 2
•
Ceramic Refractory, 2
You will need a Phillips screwdriver to install the front.
The fireplace installation should be complete and in-
spected. Any surround and trim assemblies should also
be installed before setting the front face in position.
Installation
1. Remove the upper louvre section from the DV fire-
box front.
2. Fasten the two top brackets at the existing holes in
the upper inside lip of the firebox. Use the left hole
on the left bracket and the right hole on the right
bracket. (Fig. 1)
3. Place two (2) ceramic refractory pieces into window
assembly. (Fig. 2) CAUTION: The ceramic refractory
pieces are very fragile, handle with care!
•
Base Grille Assy.
•
Base Trim Piece
•
Knob Ext., Hi/Lo
•
Knob Ext., Piezo
Top Hanger
Brackets
Fig. 1 Be sure that each of the steel brackets is securely at-
tached to the fireplace frame.
4. Hang the window panel on the firebox front by en-
gaging its upper rail over the back of the top of the
KT232
firebox opening frame. (Fig. 2)
DV36/39 bay front
•
Remove the protective film from the brass trim
hanger brackets
sections, if applicable.
6/19/01 djt
Upper Rail
Ceramic
Refractory
Fig. 2 Cast window panel shown, Steel window mounts in the
same manner.
5. The base trim piece is used to close a gap that might
exist between the base grille and a lower hearth.
Attach the trim section to the base grille by engaging
the narrow flange to the clips on the underside of the
base grille. (Fig. 3)
Use the
outermost
hole
Ceramic
Refractory
KT233
KT233
DV36/39 bay front
window panel
6/20/01 djt
30000429 8/08 Rev. 4
KT232