Connecting To The A 4565 And The A 4585; Dip Switch Settings - Redback A 4595A Operating Manual

Redback® A 4595A School Lockdown Controller
3.6 CONNECTING THE LOCKDOWN CONTROLLER TO THE A 4565 ALERT/EVAC CONTROLLER
AND THE A 4580 16 ZONE PAGING SYSTEM.
A complete Fire Evacuation and paging system can be configured when the A 4595A is connected to the A 4565
Alert/Evacuation Controller and the A 4580 16 Zone Paging System.
In order to allow the A 4595A and the A 4565 to be fed through the paging system, the wiring diagram shown in Fig 3.6
must be followed. The audio output of the A 4595A is fed into the BGM (background music input) of the A 4565. The
Audio output of the A 4565 is then fed into the Evac input of the A 4580. If background music is required this is fed into
the BGM input of the A 4580, not the A 4565.
The A 4565 has the highest priority in this setup and will override any lockdown condition.

DIP Switch Settings

IMPORTANT NOTE
SW On O
Ensure power is switched o when
1 Loop MP3
Play MP3 once adjusting DIP switches. New
24V DC 24V DC
settings will be e ective when
2-8 Not Used
IN power is switched back on.
IN
DIP Switches
1 2 3 4 5 6 7 8
+ _
Micro SD Card
- +
1 2 3 4 5 6 7 8
(16GB Maximum)
www.redbackaudio.com.au
IMPORTANT NOTE
Ensure power is switched o when
24V DC 24V DC DC FUSE
adjusting DIP switches. New
IN IN settings will be e ective when
power is switched back on.
DC FUSE
Made in Australia by
Altronic Distributors DIP Switches
Pty Ltd
1 2
SD Card
- +
(2A M205) 1 2 3 4 5 6 7 8
(16GB Maximum)
From
24V
24V DC 24V Switched Evac
L
IN BATTERY Out Trigger
Micro
R
SD Card
+ _ 16GB PA Out
120mA
- +
Max Maximum
Manufactured in Australia By Altronic Distributors Pty. Ltd.
3.7 DIP SWITCH SETTINGS
Switch 1
This switch determines the MP3 play mode.
When set to "ON" the triggered MP3 audio file will play in a continuous loop.
When set to "OFF" the triggered MP3 audio file will play only once.
Switch 2-8 Not Used.
16 Redback® Proudly Made In Australia
All Clear Lock In Standby Lock Out
Contacts
24V Out 24V Out 24V Out 24V Out
All switched outputs limited to 120mA maximum current draw
Fire Evac Alert Bell
Contacts 24V Out 24V Out 24V Out 24V Out
3 4 5 6 7 8
All switched outputs limited to 120mA maximum current draw
1 2
DIP Switch Settings
SW
L
1 Single Amp Mode
2 Line Level
24V Out Trigger
3
ON-Evac/OFF-Any
4-8 Not Used
R
1 2 3 4
BGM Out BGM Input Zone 17-32 3 To Paging Consoles 4
Evac Input
1 2 3 4 5 6 7 8
Extender (Maximum 500mA per output)
The Evac Input VOX sensitivity
is set by the "EVAC VOX" trimpot
on the front of the A 4580.
Ensure power is switched off when adjusting DIP switches.
New settings will be effective when power is switched back on.
A 4595A LOCKDOWN CONTROLLER
1 2
Bell/Pre-Bell Common Emergency
24V Out 24V Out 24V Out
3 4
Interface 1 Interface 2 To Wall Plates
Output volume set by
master volume.
A 4565 ALERT/EVAC CONTROLLER
Common
1 2
24V Out
PA Mic Evac
Interface 3 To Wall Plates 4 To Paging
Vol Vol
(Maximum 500mA per output) Console
A 4580 COMMUNICATOR
100V Switching - 1 AMP SYSTEM - Connect PA amp 100V output to "From PA AMP" Terminals
On
O 2 AMP SYSTEM - Connect PA amp 100V output to "From PA AMP" terminals and BGM amp 100V ouput to "From BGM AMP terminals.
Dual Amp Mode Connect Zone ampli er speakers to "+" and "-" terminals.
Speaker Level Preamp Switching - Connect Zone ampli er line level inputs to "+" , " - " and "
Zones
16/32 15/31 14/30 13/29 12/28 11/27 10/26 9/25 8/24
5 6 7 8
- + - + - + - + -
- + - + - + - +
Fig 3.6
IMPORTANT NOTE:
When using the A 4595A
1 2
Lockdown Controller, the
L
A 4565 Alert/Evac
Made in Australia by
Altronic Distributors
R
Pty Ltd
www.redbackaudio.com.au Controller and the A 4580
3 4 Mp3 Master Audio
To Paging Consoles
Volume Volume Out
16 Zone Communicator
together in a system, the
following wiring diagram
must be followed.
The A 4565 has the
highest priority in this
system and will over-ride
any lockdown condition.
Connections:
L L L
The Audio output from
R R R
the A 4595A Lockdown
Bell Fire V/Over Chime Audio BGM BGM Audio
Vol Vol Vol Vol In In
Out Volume
controller is fed into the
BGM (Background Music)
input on the rear of the
BGM Input Level
set by the BGM
A 4565 Evac Controller.
Volume trimpot.
The Audio output from
the A 4565 is then fed
into the Evac input of the
A 4580 paging system.
If background music is
required through the
" terminals. From From
system it is connected to
PA BGM
7/23 6/22 5/21 4/20 3/19 2/18 1/17 AMP AMP
the BGM input on the
+ _ _
+ -
+
+ rear of the A 4580 (Not
- + - + - + - + - + - + - +
+ -
the A 4565).
www.altronics.com.au