Maintenance; Maintenance Schedule - Alto-Shaam 500-1D Operator's Manual

Maintenance Schedule

Requirements
Daily
Weekly
Monthly
Yearly
Dr a we r W a rm e r Op er a to r ' s Ma n u al
▪
▪
See topic How to Clean the Drawer Warmer.
▪
Disconnect the drawer warmer from power source and let cool.
For daily maintenance, do the following.
▪
Remove
any spills with disposable paper wipes or a damp cloth.
▪
Wipe the outside of the drawer warmer with a damp cloth.
▪
Check the display screen for cracking or peeling. Contact Technical Service if
needed.
For weekly maintenance, do the following.
▪
Clean
the entire drawer warmer.
pad.
▪
Do not spray the cleaner directly into the fan openings located in the rear of the
drawer warmer.
For monthly maintenance, do the following.
▪
Inspect drawers and drawer rails.
▪
Inspect drawer vent slides for proper operation (if applicable).
▪
Calibrate the temperature sensor.
▪
Inspect
door handle screws and tighten if necessary.
For yearly maintenance, do the following.

NOTE:
Must be performed by a qualified professional.
▪
Check and tighten
all wire connections.
▪
Measure
the current draw.
▪
Test the heating elements for electrical short to ground.
▪
Inspect the condition of the cord and plug.
▪
Check and tighten the cord connection inside of the appliance control area.
▪
Measure the site voltage.
▪
Inspect and adjust voltage monitor board if needed.
▪
Inspect and test the control and control functions.
▪
Calibrate the temperature sensor.
M N- 46 9 6 9 Rev 1 5 /2 0
▪ ▪ ▪
M
Make sure
to use a non-abrasive nylon scrub
AINTENANCE
33