Speed Adjusting Dial - Makita DUR361U Instruction Manual

For model DUR361U
1
2
013807
For model DUR362L
1
2
014158
To prevent the switch trigger from being accidentally
pulled, a lock-off lever is provided.
To start the tool, turn the lock-off lever and then pull the
switch trigger. Release the switch trigger to stop.
NOTE:
After the power button is pushed and the tool is
•
left one minute without any operations, the tool is
automatically powered off.
Reversing Switch for Debris Removal
WARNING:
Always be sure that the tool is switched off
•
and battery cartridge is removed before
removing weeds or debris entangled in the tool
that could not be removed when operated in
the reverse mode. Failure to switch off and
remove the battery cartridge may result in serious
personal injury from accidental start-up.
For model DUR361U
2
013835
1. Lock-off button
2. Switch trigger
1. Lock-off lever
2. Switch trigger
1. Reversing switch
2. A position
depressed for
normal
operation
3. B position
3
depressed for
weed and debris
1
removal
For model DUR362L
1
B
A
2
014159
This tool has a reversing switch which is only provided
to change the direction of rotation so that it can be used
to remove weeds and debris entangled in the tool. To
operate the tool normally the "A" side of the switch
should be depressed.
To remove weeds and debris that are jammed in the
rotating head the tool can be reversed by depressing
the "B" side of the switch. In the reverse position the
tool will only operate for a short period of time and
automatically shut off.
NOTICE:
Always check the direction of rotation before
•
operation.
Use the reversing switch only after the tool comes
•
to a complete stop. Changing the direction of
rotation before the tool stops may damage it.

Speed adjusting dial

014748
The tool speed can be adjusted by turning the adjusting
dial. Turn the speed adjusting dial clockwise for higher
speed, and counterclockwise for lower speed.
Nylon cutting head (optional accessory for a
product that comes with a cutter blade)
Nylon cutting head
NOTICE:
Do not attempt to bump feed the head while the
•
tool is operating at a high RPM. Bump feeding at a
high RPM may cause damage to the nylon cutting
head.
The bump feed will not operate properly if the
•
head is not rotating.
12
1. Reversing switch
3
2. A position
depressed for
normal operation
3. B position
depressed for
weed and debris
removal
1. Speed adjusting
dial
1