Installing The Guard - Makita DUR361U Instruction Manual

Cordless grass trimmer

Hide thumbs Also See for DUR361U:

Instruction manual (172 pages)

Technical information (16 pages)

Instruction manual (129 pages)

Table Of Contents

Table of Contents

014839

The nylon cutting head is a dual string trimmer head

provided with a bump & feed mechanism.

To cause the nylon cord to feed out, the cutting head

should be bumped against the ground while rotating at a

low RPM.

NOTE:

If the nylon cord does not feed out while bumping the

head, rewind/replace the nylon cord by following the

procedures described under "Maintenance."

ASSEMBLY

WARNING:

Always be sure that the tool is switched off

•

and battery cartridge is removed before

carrying out any work on the tool. Failure to

switch off and remove the battery cartridge may

result in serious personal injury from accidental

start-up.

Never start the tool unless it is completely

•

assembled. Operation of the tool in a partially

assembled state may result in serious personal

injury from accidental start-up.

Installing the handle

For model DUR361U

012456

Insert the shaft of the handle into the grip as shown.

Align the screw hole in the grip with the one in the shaft.

Tighten the screw securely.

Fit the barrier and grip onto the shaft pipe with four

screws. Make sure that the spacer on the shaft pipe is

located between the grip/barrier assembly and the

hanger.

1. Most effective

cutting area

1. Grip

2. Handle

3. Screw

014752

Place handle between handle clamp and handle holder.

Adjust the handle to an angle that provides a

comfortable working position and then secure by firmly

hand-tightening knob.

For model DUR362L

014753

Fit the grip onto the shaft pipe and tighten it with two

hex bolts. Make sure that the spacer on the shaft pipe is

located between the grip assembly and the other grip.

Do not remove or shrink the spacer.