Maintenance - Makita DUR361U Instruction Manual

As shown in the figure, put the shoulder harness on
your left shoulder by putting your head and right arm
through it and keep the tool on your right side while
always keeping the barrier in front of your body.
Attachment of shoulder harness
1
2
014156
After putting the shoulder harness on it can be attached
to the tool by connecting the buckles provided on both
the tool hook and the harness. Be sure that the buckles
click and lock completely in place.
Detachment
014751
The buckle is provided with a means of quick release
which can be accomplished by simply squeezing the
sides and the buckle.
WARNING:
Be extremely careful to maintain control of the tool
•
at all times. Do not allow the tool to be deflected
toward you or anyone in the work vicinity. Failure
to keep control of the tool could result in serious injury
to the bystander and the operator.

MAINTENANCE

WARNING:
Always be sure that the tool is switched off
•
and battery cartridge is removed before
attempting to
maintenance on the tool. Failure to switch off
and remove the battery cartridge may result in
serious personal injury from accidental start-up.
NOTICE:
Never use gasoline, benzine, thinner, alcohol or
the like. Discoloration, deformation or cracks may
result.
1. Buckle
2. Hook
1. Buckle
1
perform inspection
Supply of grease to gear case
2
014840
Supply grease (Shell Alvania 2 or equivalent) to the
gear case. Remove the hex bolt and then put grease
through the grease hole every 30 hours. (Genuine
Makita grease may be purchased from your Makita
dealer.)
Replacing the nylon cord
WARNING:
Make sure that the cover of the nylon cutting
•
head is secured to the housing properly as
described below. Failure to properly secure the
cover may cause the nylon cutting head to fly
apart resulting in serious personal injury.
013822
Take off cover from housing, pressing two latches which
are slotted section oppositely on side of housing.
013823
Cut a nylon line in 3-6 m. Fold the cutting line in two
or
halves, leave one of half longer 80-100 mm than
another.
17
1. Gear case
1
2. Hex bolt
1. 80-100 mm
1