Operation - Makita DUR361U Instruction Manual

Hex wrench storage
014747
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.

OPERATION

Correct handling of tool (DUR361U)
Correct posture
WARNING:
Always position the tool on your right-hand
•
side so that the shaft of the left handle is
always in front of your body. Correct positioning
of the tool allows for maximum control and will
reduce the risk of serious personal injury caused
by kickback.
014750
As shown in the figure fit the shoulder harness and
hang the tool firmly on your right side so that the shaft of
the left handle is always ahead of you.
Attachment of shoulder harness
1
2
014769
Wear the shoulder harness on your back and buckle it
up until a click is heard. Make sure that it cannot be
taken off with pulling it off. Hang the tool as shown.
1. Hex wrench
1
1. Buckle
2. Hook
WARNING:
Be extremely careful to maintain control of the tool
•
at this time. Do not allow the tool to be deflected
toward you or anyone in the work vicinity. Failure
to do so could result in serious injury.
Adjustment of the hanger position and shoulder
harness
When replacing battery or accessories with others, the
weight balance of the tool may change. In such case,
adjust the hanger position and shoulder harness length
as follows.
To change the hanger position, loosen the fixing screw
on the hanger with the supplied wrench and then move
the hanger and the cushion. The cushion can be moved
easily by twisting it.
1
750 mm
750 mm
012478
Adjust the hanger position and shoulder harness length
so that:
− the hanger positions 750mm or higher from the
ground,
− the cutting tool positions 100mm to 300mm high
from the ground and
− the unguarded part of cutting tool is horizontally
750mm or farther away from the hanger.
After adjusting the hanger position, tighten the screw
with the wrench securely.
Correct handling of tool (DUR362L)
Correct posture
WARNING:
Always position the tool on your right-hand
•
side so that the barrier is always in front of
your body. Correct positioning of the tool allows
for maximum control and will reduce the risk of
serious personal injury caused by kickback.
014838
16
1. Hanger
100 - 300 mm