Table of Contents
Advertisement
Bluetooth®
*1 This adjustment will not affect the volume of the other sources.
*2 Press and hold VOL
to continuously increase the volume to 15.
*3 Operations may vary according to the connected Bluetooth device.
Improve the voice quality
While talking on the phone...
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select an item (see the following table), then
press the knob.
3
Repeat step 2 until the desired item is selected or activated.
4
Press and hold
to exit.
To return to the previous setting item, press
[MIC GAIN]
[LEVEL –10] to [LEVEL +10] ([LEVEL –4]): The sensitivity of the
microphone increases as the number increases.
[NR LEVEL]
[LEVEL –5] to [LEVEL +5] ([LEVEL 0]): Adjust the noise reduction level
until the least noise is being heard during a phone conversation.
[ECHO CANCEL]
[LEVEL –5] to [LEVEL +5] ([LEVEL 0]): Adjust the echo cancellation
delay time until the least echo is being heard during a phone conversation.
Make the setting for receiving a call
1
Press
to enter Bluetooth mode.
2
Turn the volume knob to select an item (see the following table), then
press the knob.
3
Repeat step 2 until the desired item is selected or activated.
4
Press and hold
to exit.
To return to the previous setting item, press
[SETTINGS]
[AUTO ANSWER] [1] to [30]: The unit answers incoming call automatically in the selected
[BATT/SIGNAL]* [AUTO]: Shows the strength of the battery and signal on the supplementary
* Functionality depends on the type of the phone used.
Make a call
You can make a call from the call history, phonebook, or dialing the number.
.
Call by voice is also possible if your mobile phone has the feature.
Default: [XX]
1
2
3
4
To return to the previous setting item, press
[CALL HISTORY]
.
time (in seconds). ; [OFF]: Cancels.
display (page 32) when the unit detects a Bluetooth device and the
Bluetooth device is connected. ; [OFF]: Cancels.
Press
to enter Bluetooth mode.
"(First device name)" appears.
• If two Bluetooth phones are connected, press
other phone.
"(Second device name)" appears.
Turn the volume knob to select an item (see the following table), then
press the knob.
Repeat step 2 until the desired item is selected/activated or follow the
instructions stated on the selected item.
Press and hold
to exit.
(Applicable only if the phone supports PBAP.)
1 Press the volume knob to select a name or a phone number.
• "INCOMING," "OUTGOING" or "MISSED" is shown on the lower part of
the display to indicate the previous call status.
• Press DISP to change the display category (NUMBER or NAME).
• "NO DATA" appears if there is no recorded call history or call number.
2 Press the volume knob to call.
Default: [XX]
again to switch to the
.
17
ENGLISH
Hide quick links:
Advertisement
Table of Contents
