Getting Started; How To Replace The Battery; Select The Display Language And Cancel The Demonstration - Kenwood DPX-M3200BT Instruction Manual

Basics
Remote control (RC-406)
Remote sensor
(Do not expose to bright sunlight.)

How to replace the battery

To On the remote control
Adjust the volume Press VOL
• Press and hold VOL
the volume to 15.
Press ATT during playback to attenuate the sound.
• Press again to cancel.
Select a source Press SRC repeatedly.
Turn off the power Press and hold SRC to turn off the power.
( Pressing SRC does not turn on the power. )
Pull out the insulation sheet when
using for the first time.
or VOL .
to continuously increase

Getting Started

1

Select the display language and cancel the demonstration

When you turn on the power for the first time (or [FACTORY RESET] is set to
[YES], see page 7), the display shows: "SEL LANGUAGE" "PRESS"
"VOLUME KNOB"
1
Turn the volume knob to select [ENG] (English) or [TUR] (Turkish), then
press the knob.
[ENG] is selected for the initial setup.
Then, the display shows: "CANCEL DEMO" "PRESS" "VOLUME KNOB".
2
Press the volume knob again.
[YES] is selected for the initial setup.
3 Press the volume knob again.
"DEMO OFF" appears.
Then, the display shows the selected crossover type: "2-WAY X ' OVER" or
"3-WAY X ' OVER"
• To change the crossover type, see "Change the crossover type" on
page 7.
5
ENGLISH