Removing The Chassis From The Pallet - Cisco NCS 4000 Series Unpacking, Moving, And Securing Manual

Removing the Chassis from the Pallet

Removing the Chassis from the Pallet
This procedure describes how to remove the support brackets that secure the chassis to the pallet.
Figure 2-3
1
Required Tools and Equipment
•
•
Steps
To remove the chassis from the pallet and then transfer the chassis to a moving device, follow these steps:
Using the Phillips #2 screwdriver, remove the fourteen M4 screws that connect the right support bracket
Step 1
to the chassis.
Cisco Network Convergence System 4000 Series Unpacking, Moving, and Securing Guide
2-4
Hardware Locations for Support Brackets
28 M4 screws (14 on each side)
Number 1 and number 2 Phillips screwdrivers
3/8-in. socket wrench or 3/8-in. drive ratchet wrench
Chapter 2
2
8 bolts with washers (4 on each side)
Unpacking the Chassis