Attaching The Dolly To The Chassis And Removing The Chassis Pallet - Cisco Network Convergence System 6000 Series Unpacking, Moving, And Securing Manual
6000 series network convergence system routers unpacking, moving, and securing guide
Hide thumbs
Also See for Network Convergence System 6000 Series:
- Unpacking, moving, and securing manual (52 pages)
Table of Contents
Advertisement
Chapter 2
Figure 2-4
Note
When you are ready to remove the chassis bag, unseal the tape that exists around the perimeter of the
Step 8
chassis base and pull the bag off the chassis.
Attaching the Dolly to the Chassis and Removing the Chassis
Pallet
This section describes how to attach the dolly to the Cisco NCS 6008 chassis to remove the chassis
shipping pallet and prepare to move the chassis into place. Only the 90-degree dolly configuration is used
to remove the chassis from the pallet.
Figure 2-5
when performing the steps to attach the dolly to the chassis in this section.
OL-29233-01
Remove Four Top Cover Bolts From Chassis Shipping Box
Do not remove the chassis bag until you are ready to move and install the chassis.
shows the dolly instruction label on the inside component of the dolly. Refer to this figure
Cisco Network Convergence System 6000 Series Routers Unpacking, Moving, and Securing Guide
Attaching the Dolly to the Chassis and Removing the Chassis Pallet
2-5
Advertisement
Table of Contents
Need help?
Do you have a question about the Network Convergence System 6000 Series and is the answer not in the manual?
Questions and answers