Removing And Installing A Chassis; Removing A Chassis From The Equipment Rack - Cisco 12010 series Maintenance Manual

Chapter 7 Maintaining the Router

Removing and Installing a Chassis

Removing a Chassis from the Equipment Rack

Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Step 8
OL-11496-01
This section provides the procedures to remove and replace a chassis. You may
need to perform this procedure to replace a defective chassis or move it to another
location. These instructions include the steps directing you to removal and
replacement instructions for individual components such as power supplies and
line cards.
Use the following procedure to remove the chassis and its components from the
equipment rack.
Power off the router (see
Power off the circuit breakers to the power supplies.
Disconnect the power cords from the PDUs on the rear of the chassis.
For AC PDUs, see
•
For 2400 W DC PDUs, see
•
page 7-48.
For 2800 W DC PDUs, see
•
page 7-48.
Disconnect the supplemental bonding and grounding connection (if there is one)
from the chassis (see Supplemental Bonding and Grounding Connections,
page 3-28).
Remove the front covers (see
Remove the power supplies (see
page 7-32, or Removing and Replacing a DC PEM, page
Remove the blower module (see
page 7-23).
Disconnect RP cables connected to the console port, auxiliary port, or either of
the Ethernet ports, RJ-45 or MII.
Label each of the RP cables before you disconnect the cables.
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
Powering Off the Router, page
Step 5 of Removing and Replacing an AC PDU, page
Step 6 of Removing and Replacing a DC PDU,
Step 7 of Removing and Replacing a DC PDU,
Removing the Front Covers, page
Removing and Replacing an AC PEM,
Removing and Replacing the Blower Module,
Removing and Installing a Chassis
7-2).
7-3).
7-41).
7-37.
7-69