Placement - Hussmann VR3-M Series User Manual

Installation (cont'd)

Placement

Important: See lifting instructions to properly lift
case when being placed on dollies or permanent
location. (See page 7 for Lifting Instructions.)
Leave all hardware and fittings in place until
case is located at or near its preferred location.
Using a J-Bar lift the case from the 2x4 boards
and placing dollies underneath each Base Leg,
proceed to moving the case to its designated
location if not done so already.
IF APPLICABLE
(NOT ALL CASES CONTAIN LEG BRACES)
The Illustration Below demonstrates perfect
placement of a dollie per 1 side for both Base
Legs of the merchandiser.
IF APPLICABLE
(NOT ALL CASES
CARRY LEG BRACES)
Move the fixture as close as possible to its per-
manent location and then remove all packag-
ing and prepare to remove off Skid. Remove all
separately packed accessories such as kits, and
panels. Check for damage before discarding
packaging.
Remove screws as well as fastened plates
bolted to each 2x4 board at each base leg.
Remove fastened plates only upper Brace Legs
are to remain fastened onto case.
Fastened plate
Once the fastened plates are removed a J-Bar
can be used to lift at each end of the Leg Braces
to remove the below 2x4 boards.
6