Front Deck Pan Placement; Caution:when Reassembling The Front Self-Service Por; Tion Of The Case, Assure Proper Installation Of Bottom Deck Pan; Non-Glare Glass (Optional) - Hussmann CR3-F Installation And Operation Manual

Combination service and self-service meat /fish case with rear storage
Hide thumbs Also See for CR3-F:
Table of Contents

Advertisement

Rev. 0707
Case Cleaning continued

FRONT DECK PAN PLACEMENT

ATTENTION!
When reassembling the front self-service
portion of the case, assure proper
installation of bottom deck pan. If the deck
pan is NOT installed properly, the front
self service section will NOT maintain safe
product temperature.

NON-GLARE GLASS (Optional)

The high optical clarity of this glass is possible due
to special coatings on the glass surface itself. To
preserve this coating and the optical clarity, keep the
glass clean.
Water is the only solution recommended to be used
to clean the non-glare glass. The damage to the glass
from improper, caustic solutions is irreparable.
In addition to cleaning the glass with the recommended
product, there are precautions that should be taken
when working and cleaning the inside of the case.
• When cleaning the inside of the cases, we
recommend that the glass be fully opened and
covered to prevent to prevent solutions from
splashing onto the glass and ruining the coating
on the inside.
* Only use a soft cloth and water (in a spray
bottle) for cleaning any glass or mirrored
components. Be sure to rinse and/or dry
completely.
• Never use hot water on cold glass surfaces!
It may shatter and cause serious injury!
Allow glass surfaces to warmed to room
temperature.
Plexiglas & Acrylic Care/Cleaning
PLEXIGLAS & ACRYLIC CARE
Improper cleaning not only accelerates the cleaning
cycle but also degrades the quality of this surface.
Normal daily buffi ng motions can generated static
cling attracting dust to the surface. Incorrect cleaning
agents or cleaning cloths can cause micro scratching
of the surface, causing the plastic to haze over
time.
CLEANING
Hussmann recommends using a clean damp chamois,
or a paper towel marked as dust and abrasive free
with 210
Plastic Cleaner and Polish available by
®
calling Sumner Labs at 1-800-542-8656. Hard, rough
cloths or paper towels will scratch the acrylic and
should not be used.
ANTISTATIC COATINGS
The product 210
®
not only cleaning and polishing the Plexiglas surface,
but also providing antistatic and anti-fog capabilities.
This product also seals pores and provides a
protective coating.
13
has proven to be very effective in

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cr3-mR3-fR3-mR3hv-mR3hv-fCr3hv-m ... Show all

Table of Contents