Advertisement
Your kit contains the following parts. Please check your kit for any missing or damaged parts before starting construction.
1 Plan Sheet
1 1/16"x12" Landing Gear Wire
1 Plastic Spinner
4 3/32"x3/16"x18" Balsa Strip
1 9" Plastic Propeller
1 Nylon Propeller Bearing
1 3/16"x60" Rubber Strip
Tools and Building Supplies
You will need the following items to assemble this model. You must read and follow all of the manufactures
instructions provided with these items!
-Glue
-Cutting Tools
-Clear Dope, Thinner & paint brush
-320 and 400 grit sandpaper
-Straight Pins
-Wax Paper
-Needle nose pliers
-1/4" Drill Bit
-Building Board
COMPLETE KIT PARTS LIST
2
Decal Sheet
1
Tailwheel Assy.
11 1/16"sq.x18" Balsa Strip
1
3/16"x2" Birch Dowel
1
Propeller Shaft
2
Plastic Wheels
1
Laser Cut Plywood Disk (N-1)
CA, White Glue, Sigment or Ambroid all work well.
A hobby knife with a #11 blade is used for general cutting. A single edge
razor blade is also a useful cutting tool.
2
Gray Tissue
1
Plastic Canopy
22 3/32"sq.x18" Balsa Strip
1
Instruction Manual
2
Brass Washer
2
1/16" Plastic Wheel Retainers
5
Laser Cut Sheets
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for SIG Award Winning Model Designs P-51D Mustang
Summary of Contents for SIG Award Winning Model Designs P-51D Mustang
- Page 1 Your kit contains the following parts. Please check your kit for any missing or damaged parts before starting construction. COMPLETE KIT PARTS LIST 1 Plan Sheet Decal Sheet Gray Tissue 1 1/16"x12" Landing Gear Wire Tailwheel Assy. Plastic Canopy 1 Plastic Spinner 11 1/16"sq.x18"...
-
Page 2: Building The Tail Surfaces
The first thing that you need to do is to identify and mark the part numbers on the laser cut parts using the drawings on the following pages as a guide. It is possible that several of the laser cut parts may not be completely cut through. If this is the case you can free the part from the sheet quickly using an X-acto knife. -
Page 3: Building The Fuselage
Building the Fuselage 5. Build the fuselage side frames over the plan using the laser cut parts F-A and one F-B. The remaining pieces of the side frames are made from 3/32" sq. balsa strip. Splice the top longeron as shown on the plan. 6. -
Page 4: Cover The Model
27. Raise the wing tip 1 3/8" at W-8 and glue the left wing to the center section. 28. Glue the right wing panel to the center section as you did the left. 29. Glue the 1/16" sq. leading edge spars into position, cracking them at ribs W-2 and W-3. These strips should extend past W- 8 at the wing tip. -
Page 5: Safety Rules
LIMIT OF LIABILITY: In use of our products, Sig Mfg. Co.'s only obligation shall be to replace such quantity of the product proven to be defective. User shall determine the suitability of the product for his or her intended use and shall assume all risk and liability in connection...
Need help?
Do you have a question about the Award Winning Model Designs P-51D Mustang and is the answer not in the manual?
Questions and answers