Toro TX 1000 Operator's Manual page 36

Removing the Battery
1. Park the machine on a level surface, engage the parking brake, and lower the loader arms.
2. Shut off the engine and remove the key.
3. Remove the battery as shown in
Charging the Battery
WARNING
Charging the battery produces gasses that can
explode.
Never smoke near the battery and keep sparks and
flames away from battery.
Important: Always keep the battery fully charged (1.265
specific gravity). This is especially important to prevent
battery damage when the temperature is below 0°C
(32°F).
1. Remove the battery from the machine; refer to
Removing the Battery (page
2. Charge the battery for 4 to 8 hours at a rate of 3 to 4 A
(Figure 52). Do not overcharge the battery.
Figure 51.
Figure 51
36).
4
2
1. Positive battery post
2. Negative battery post
3. When the battery is fully charged, unplug the charger
from the electrical outlet, then disconnect the charger
leads from the battery posts
36
3
1
G003792
Figure 52
3. Red (+) charger lead
4. Black (-) charger lead
(Figure 52).
g204573
g003792