Safety and Notice The AV-GM04S3-S1 HDMI 2.0 Extender over Single Cat.X with HDBaseT, RS-232, Bi-directional has been tested for conformance to safety regulations and IR, Ethernet & PoC requirements, and has been certified for international use. However, like all electronic equipment the AV-GM04S3-S1 should be used with care.
INTRODUCTION HDMI 2.0 Extender over Single Cat.X with HDBaseT, RS-232, The AV-GM04S3-S1 Bi-directional IR, Ethernet & PoC boosts up your video/audio transmission distance up to 100m (330ft) in HDTV 1080p with 48-bit color depth and 70m (230ft) at 4K-HDR. AV-GM04S3-S1 has new generation technology which makes sure the HDBaseT extender can support HDMI2.0a and HDCP 2.2.
PANEL DESCRIPTIONS Transmitting unit ► AV-GM04S3-S1-TX Front Panel HDMI IN: Connect to a HDMI source with a HDMI male-male cable Stereo Input: Provide a channel to extend an external analog audio to receiver over HDBaseT S/PDIF Output: remote ARC output IR Blaster: Infrared 3.5mm socket for plugging in the extension cable of IR blaster IR Receiver: Infrared 3.5mm socket for plugging in the extension cable of IR receiver USB: Connect to USB Device...
Receiving unit ► AV-GM04S3-S1-RX Front Panel HDMI OUT: Connect to a HDMI display with a HDMI male-male cable Stereo Output: External analog audio output from transmitter over HDBaseT S/PDIF Output: local ARC output IR Blaster: Infrared 3.5mm socket for plugging in the extension cable of IR blaster IR Receiver: Infrared 3.5mm socket for plugging in the extension cable of IR receiver USB: Connect to USB Device Mini-USB: Connect to USB Host...
Page 9
PIN#2 PIN#3 ON [] ON [] Firmware Update Mode +24V DC: Connect to a 24V DC power supply. *DIP Switch Position (TX/RX)
HARDWARE INSTALLATION 1. Connect a HDMI or DVI source (such as a Blu-ray Disc player) to the transmitting unit AV-GM04S3-S1-TX. 2. Connect a HDMI or DVI display (such as a LCD TV) to the receiving unit AV-GM04S3-S1-RX. 3. Connect IR Blaster/Receiver to both TX and RX units. 4.
IR PASS-THROUGH IR Extenders IR Blaster IR Receiver IR Sockets IR BLASTER: plug in the IR blaster to emit all IR command signals received from the IR receiver from the other end to control the devices corresponding to the IR signals. IR RECEIVER: plug in the IR receiver to receive all IR command signals from the IR remote controls of the corresponding devices.
NOTICE 1. All HDMI over CAT5 transmission distances are measured using Belden 1583A CAT5e 125MHz UTP cable and ASTRODESIGN Video Signal Generator VG-859C & VG-870B. 2. Incorrect placement of IR Blaster and Receiver may result in the failure of the IR extenders.
Also, the technical information contained herein regarding the AV-GM04S3-S1 features and specifications is subject to change without further notice. Support For more info or tech support http://www.siig.com/support...
Need help?
Do you have a question about the AV-GM04S3-S1 Series and is the answer not in the manual?
Questions and answers